LEAK TRACY

Leak-Tracy for use with pressurized gas and non-pressurized flow systems using Leak-Tracy DLT series of leak tracing fluid. Leak-Tracy is a highly developed leak detection system, capable of detecting microscopic leaks up to 1 x 10-6 cc/sec, when properly applied. Leak-Tracing is an important part of insuring flow system integrity. With Leak-Tracy there is no compromise and upon completion of your Leak-Tracing, you can be sure the system is safe and secure.

Leak-Tracing is straightforward and simple.

Application:Liberally apply Leak-Tracy to all seams, joints and connection points to verify they are secure or detect a leak. Leak-Tracy visually points out the location of a leak. Clear, living bubbles detect the leak point. The bubbles are designed to grow and last, giving positive leak detection.

Good News – No Bubbles = No Leak! Move on and continue Leak-Tracing with the next joint point until the entire system has been Leak-Traced.

Remember, it is as important to not find a leak as it is to detect a leak! This is the Tracing Process, using Leak-Tracy..

Leak-Tracing should be performed on all pressurized gas systems to insure there is no leak. The pressured gas itself can be used to trace for leaks. Leak-Tracy is manufactured with pure chemistries to insure that it will neither interfere with the pressurizing gases, nor leave an objectionable residue as may be found with inferior products. Leak-Tracy formulations are designed to meet general and specific applications. DLT-77 is General Purpose, suited for most applications down to freezing. DLT-19 is suited for cold weather tracing down to 10º F. (-19º C). For Oxygen Systems, to meet MIL Specification MIL-PRF-25567, Type 1, we recommend DLT-102, Temperature Range 32ºF (0º C) to 160º F (71º C). For super cold environments, there is DLT-65, for a Type 2 Temperature Range of - 65ºF (- 54ºC) to +104ºF (40ºC).

Leak-Tracy works practically everywhere! Leak-Tracy is used for general purpose and in unique settings like Nuclear Installations, Hospital Oxygen Networks, Food Processing Systems and many other critical applications. Leak-Tracing is done on New Installations, Repaired Sites, Problem Areas, and Suspected Locations, to insure the integrity of the system. It is also used for non-pressurized tanks and piping systems, by injecting low pressure air or inert gas to check welds and flanges for leaks before commissioning.

Leak-Tracy will not stress Stainless Steel or PVC/Plastic piping systems. Leak-Tracy will not cause corrosion or leave problematic residue. It is non-toxic and is in compliance with professional and commercial specifications fHigh-Tech leak detecting applications.

Under the Red Cap is the Pull Out "Squirter Tube" that lets yget to hard to reach places and accurately apply Leak-Tracyas needed. Vertical, Horizontal, Up, Down, Around, Behindyou can Leak-Trace.

AVAILABILITY: Cases of 48 – 8 oz. Squirter Tube Bottles

Case of 4 – 1 Gal. Plastic Bottles and in 55Gallon Drums.

DLT-77 Type 1 Leak Tracing Conditions, 32ºF (0ºC) to 160ºF (71ºC)

DLT-19 Intermediate Leak Tracing Conditions 10ºF (-19ºC) to 160ºF (71ºC)

DLT-65, Type 2 Leak Tracing Conditions, -65ºF (-54ºC) to 104ºF (40ºC)

TECH-DATA: Bulletins for Special Applications, Upon Request

Please contact us for other Leak-Tracy Products that we have not listed